Setting The Web Server Port; Setting The Refresh Rate; Configuring Library Metrics Monitoring Features - Spectra Logic T-Series Spectra T200 User Manual

Chapter 8 — Configuring the Library

Setting the Web Server Port

The library's built-in web server uses a dedicated Ethernet port to receive
input from a web browser.
1. Enter port number you want to use in the Web Server Port field. The
Do not set the web server port to 443 if you plan to access the library using the
Caution
Secure Socket Layer (SSL) protocol. Using this port number with SSL will cause the
front panel display to become unstable
2. Select Save.
3. Reset the library to enable the new web port number setting (see

Setting the Refresh Rate

The refresh rate determines how frequently the library controller refreshes
information displayed on the user interface. The default refresh rate is
60 seconds. Use the following steps to change the refresh rate.
1. Use the Refresh drop-down menu to select a scheduled interval time.
2. Select Save.

Configuring Library Metrics Monitoring Features

The library configuration includes the following metrics monitoring
features:
178
User Guide
default port number is 80. Port numbers can range from 0 to 65,535.
However, using port number 80 is strongly recommended.
Note: If you use a port number other than 80, the port number must be
explicitly entered into the web browser when accessing the
library remotely.
Resetting the Library on page
Note:
You can manually refresh the displayed information at any time
by selecting the refresh button located at the left end of the status
bar (see Status Bar on page
Drive performance – The Drive Performance Monitor allows you to
monitor the performance of your drives. To learn more, see
Your Library on page
Power consumption – The Power Consumption Monitor allows you
monitor the amount of power your library is using. To learn more, see
Monitoring Your Library on page
78).
68).
73.
73.
Monitoring
91090000