Installation Steps; Unpack And Set Up - Spectra Logic T-Series Spectra T200 User Manual

This chapter provides an overview of the hardware installation and initial
configuration performed by the Spectra-Logic-certified field engineer who
installed your library. A checklist at the end of the chapter provides space
for recording your library configuration settings for future reference.
I
NSTALLATION
During installation, the engineer performs the procedures described in the
following sections.

Unpack and Set Up

The information in this section is for reference only. This information provides a
Important
high-level summary of the installation steps is not intended for use as an
installation guide.
1. Unpack all components and verify that there was no shipping damage.
2. Install the optional BlueScale Vision camera if it was ordered with the
3. Install the library in a standard four-post, 19-inch rack at the requested
Tipping Hazard. The library must be installed in a standard 19-inch (48 cm) rack to
Warning
prevent tipping. The rack must be located on a level, hard-surfaced floor such as
cement or tile.
German: Kipp-Gefahr. Die Library muss installiert sein, in einem Standard-Rack
48 cm Ablagerung zu verhindern. Das Rack muss sich auf eine ebene, harte
Oberfläche Stock wie Zement oder Fliese.
S
TEPS
library.
Note: The BlueScale Vision camera is pre-installed in the T680 library.
location, ensuring that it is located near an easily accessible AC power
outlet and away from potential sources of static discharge (for example,
carpeted flooring).
For stability, the library is installed at the bottom of the rack.
Chapter 3
Installation Overview
57