Spectra Logic T-Series Spectra T200 User Manual page 158

Chapter 7 — Using Partitions
3. If you want to enable Automatic Drive Cleaning in this data partition,
4. If you are not logged into the encryption application or have not
Configure the Drive Loop IDs
The Fibre Channel Loop ID determines how each drive in the partition is
addressed when attached to a Fibre Channel network.
1. From the Chambers and Drives screen (or the Encryption screen), select
2. Select Soft Addressing or Hard Addressing for each of the drives listed.
3. Repeat Step 2 for each additional drive in the partition.
4. Proceed to
158
User Guide
use the Cleaning Partition drop-down list (see
select a previously created cleaning partition (see
Cleaning Partition on page
Automatic Drive Cleaning, select None.
Note: The option to select a cleaning partition is only available if you
entered an Automatic Drive Cleaning license key and
configured a cleaning partition.
configured encryption, proceed to
page 158. You can configure the partition to use encryption later, as
described in Configuring Encryption on page
If you logged into the encryption application (see
already configured encryption, the Encryption screen displays.
See Enable Encryption Using Direct-Attach Drives on page 211
information about this screen. After you complete the Encryption
screen, proceed to Configure the Drive Loop IDs on page
Next. The Fibre Channel Loop ID's screen displays.
Figure 90 The Fibre Channel Loop ID's screen.
If you select Hard Addressing, enter a value between 0 and 125 for the
Loop ID.
Configure User
Figure 76 on page
164). If you do not want to enable
Configure the Drive Loop IDs on
204.
Access.
143) to
Configuring a
page 135) and have
for
158.
91090000