Access The Interior From The Side; Check For And Remove Blockages - Spectra Logic T-Series Spectra T200 User Manual

Chapter 11 — Library Troubleshooting

Access the Interior from the Side

To access the transporter from the side of the library, use the following
steps to remove the access panels on the right side of the chassis (as viewed
from the front).
1. While holding the panel against the chassis, use a #2 Phillips
2. Using a #2 Phillips screwdriver, remove the two screws securing the

Check For and Remove Blockages

1. Examine the interior of the library and remove any blockages.
2. Use the steps in the following sections to reinstall any components you
264
User Guide
screwdriver to remove the screws securing the lower access panel to the
right side of the library (Figure 22).
Lift the bottom access panel off the chassis and set it aside.
Figure 176 Removing the right side access panels.
upper access panel to the right side of the library (see
page 264).
Rotate the bottom of the access panel outward to disengage the tabs
from the top of chassis, then lift the access panel off the chassis and set
it aside.
removed and resume operations.
The initial steps in this process depend on whether you accessed the
interior from the front (see
Panel on page 265) or from the side (see
on page 269). The remaining steps are the same for both access
methods.
Reinstall the Chamber Shelves and Front
Install the Side Access Panels
Figure 176 on
91090000