Identifying Your Printer; Making The Network Connection - Stratasys Origin One User Manual

Hide thumbs Also See for Origin One:

Table of Contents

Basic Setup

Identifying Your Printer

Use the printer nameplate to identify your printer. The printer nameplate contains the serial

number. Refer to the serial number when requesting service. The printer's model number and

power requirements are also shown on the nameplate.

The nameplate is located on the back side of the printer near the bottom, and is typically

placed near the printer's power connection. Use the information on the nameplate when

identifying your printer with Customer Support.

The Origin One Industrial and Origin One Dental printers require connection to the Origin

Cloud through the facility's network. The Origin One Local printer also requires connection to

the facility's network to reach the Origin Local Hub. An RJ45 network connector is located on

the right back corner of the printer (as viewed from the back). See

connection location.

1. Remove the Ethernet cable from the Tools and Cables Accessory Box.

2. Connect the Ethernet cable. See

A 15 ft (4.6 m) network patch cable is supplied with the printer and located in the

welcome kit. Facilities having network connection points further from the printer than

can be reached by the supplied cable, are responsible for the procurement of an

appropriate cable. The maximum Ethernet cable length is 82 ft (25 m).

Figure 2: Nameplate Location

Figure

Identifying Your Printer

Figure 3

for the network

Page 11



Table of Contents