FORTUS 360mc/400mc and FDM 360mc/400mc User Guide
Network Setup
Your system is configured for your network as a part of its initial installation
and setup. This section is provided in case you have need to change your
network settings.
Configuring the Network
1.
The network address can be Dynamic or Static.
• Dynamic address - a network server or PC will generate an IP
address for the system. A different IP address may be generated
from time to time by the server or PC.
• Static address - you must enter an IP address, subnet mask, and
gateway address for the system (provided by the system
administrator). Once entered, the address will not change.
2.
In addition to configuring the IP address, you can set the UPnP
configuration for the system.
• UPnP ON - the system will broadcast its (Unique Device Name)
UDN address across the network. This allows the Insight
workstation software to automatically detect the IP address of the
modeler for communication.
• UPnP OFF - the system will NOT broadcast its IP address across
the network. The Insight workstation software will need to be
manually configured to communicate with the modeler.
Setting the IP Address
1.
Power up the system, see
2.
From the Ready screen, select
Build Job..
Operator Control..
Modeler Status..
>Maintenance..
3.
Select
Administration
Modeler Default..
>Administration..
Reboot system..
"Powering Up the System" on
Maintenance
| *Tips: Model T16
| *
Support T16
and press ENTER.
page 4-3.
and press ENTER.
2-3