Network Setup; Configuring The Network - Stratasys Fortus 360mc User Manual

High Voltage Power Cable Connection

Network Setup

Your system is configured for your network as a part of its initial installation and
setup. This section is provided in case you have need to change your network
settings.

Configuring the Network

1.
The network address can be Dynamic or Static.
• Dynamic address - a network server or PC will generate an IP address for
• Static address - you must enter an IP address, subnet mask, and gateway
2.
In addition to configuring the IP address, you can set the UPnP configuration
for the system.
• UPnP ON - the system will broadcast its (Unique Device Name) UDN
• UPnP OFF - the system will NOT broadcast its IP address across the
Figure 2-4: Power Cable Connection
the system. A different IP address may be generated from time to time by
the server or PC.
address for the system (provided by the system administrator). Once
entered, the address will not change.
address across the network. This allows the Insight workstation software
to automatically detect the IP address of the modeler for communication.
network. The Insight workstation software will need to be manually
configured to communicate with the modeler.
Main Circuit Breaker
UPS Switch
High Voltage Power Cable Connection
2-3