Table of Contents
Advertisement
As Needed Maintenance
As Needed Maintenance
Cleaning the Exterior Surface of the Printer
The printer's exterior surfaces (doors and panels) may accumulate dust and periodically
require cleaning. Exterior doors and panels, with the exception of the touchscreen display, can
be cleaned using a slightly damp microfiber cloth (supplied in the Welcome Kit). The cloth
should be only slightly damp to ensure that water does not enter the printer. Excess water can
cause damage to interior components.
Cleaning the Touchscreen Display
As needed, to remove smudge marks and buildup, clean the touchscreen display using the
LCD cleaner and microfiber cloth provided in the Welcome Kit.
Apply an adequate amount of LCD cleaning solution to the provided microfiber cloth and then
gently wipe the exterior surface of the touchscreen display to clean its surface. It is
recommended that you apply LCD cleaner to the microfiber cloth rather than applying cleaner
directly to the touchscreen display, as excess moisture may damage the display.
Inspecting and Cleaning the Tip Shields
The tip shields may accumulate purged material or debris. As required, this material can be
removed by manually wiping the tip shields with a clean cloth. If the tip shields require
replacement, see
Caution:
Using a cleaner which contains ammonia and/or alcohol can damage the
touchscreen. Only a suitable LCD cleaning solution and microfiber cloth (included in
the Welcome Kit) should be used to clean the touchscreen display.
"Tip Shield" (page
© Copyright 2021 Stratasys. All rights reserved.
Cleaning the Exterior Surface of the Printer
202).
Page 181
Advertisement
Table of Contents
