As Needed Maintenance; Cleaning The Exterior Surface Of The Printer; Cleaning The Touchscreen Display; Inspecting And Cleaning The Tip Shields - Stratasys F170 User Manual

AS NEEDED MAINTENANCE

CLEANING THE EXTERIOR SURFACE OF THE PRINTER

The printer's exterior surfaces (doors and panels) may accumulate dust and periodically require cleaning.
Exterior doors and panels, with the exception of the touchscreen display, can be cleaned using a slightly damp
microfiber cloth (supplied in the Welcome Kit). The cloth should be only slightly damp to ensure that water does
not enter the printer. Excess water can cause damage to interior components.

CLEANING THE TOUCHSCREEN DISPLAY

Caution: Using a cleaner which contains ammonia and/or alcohol can damage
the touchscreen. Only a suitable LCD cleaning solution and microfiber cloth
(included in the Welcome Kit) should be used to clean the touchscreen display.
As needed, to remove smudge marks and buildup, clean the touchscreen display using the LCD cleaner and
microfiber cloth provided in the Welcome Kit.
Apply an adequate amount of LCD cleaning solution to the provided microfiber cloth and then gently wipe the
exterior surface of the touchscreen display to clean its surface. It is recommended that you apply LCD cleaner to
the microfiber cloth rather than applying cleaner directly to the touchscreen display, as excess moisture may
damage the display.

INSPECTING AND CLEANING THE TIP SHIELDS

The tip shields may accumulate purged material or debris. As required, this material can be removed by
manually wiping the tip shields with a clean cloth.
167