Digi IX10 User Manual page 447

Virtual Private Networks (VPN)
6. Set the hostname or IP address of the node that will be the next hop server:
(config network route service nhrp network 0 nhs 0)> nbma hostname/IP_
address
(config network route service nhrp network 0 nhs 0)>
7. Configure the overlay connection using BGP:
a. Type ... to return to the top level of the configuration schema:
(config network interface dmvpn_tunnel_interface)> ...
(config)>
b. Enable BGP:
(config)> network route service bgp enable true
(config)>
c. Set the autonomous system number for this device. For example, to set the autonomous
system number to 66007:
(config)> network route service bgp asn 66007
(config)>
d. Set the best path criteria to multipath:
(config)> network route service bgp as_path multipath-relax
(config)>
e. Add a neighbour:
(config)> add network route service bgp neighbour end
(config network route service bgp neighbour 0)>
f. Set ip to the IP address of the hub. For example:
(config network route service bgp neighbour 0)> ip 10.20.1.1
(config network route service bgp neighbour 0)>
g. Enable eBGP multihop:
(config network route service bgp neighbour 0)> ebgp_multihop true
(config network route service bgp neighbour 0)>
8. Repeat to add additional spokes.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
Dynamic Multipoint VPN (DMVPN)
447