Digi IX10 User Manual page 147

Interfaces
b. For Type, select Static IP address.
c. For Address, type the IP address and subnet of the LAN interface. Use the format IPv4_
address/netmask, for example, 192.168.2.1/24.
d. Optional IPv4 configuration items:
i. Set the MTU.
e. Enable the DHCP server:
i. Click to expand DHCP server.
ii. Click Enable.
See DHCP servers
10. See Configure DHCP relay
11. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. Enable IPv6 support.
c. For Type, select IPv6 prefix delegration.
d. For Prefix length, type the minimum length of the prefix to assign to this LAN. If the
minimum length is not available, then a longer prefix will be used.
e. For Prefix ID, type the identifier used to extend the prefix to the assigned length. Leave
blank to use a random identifier.
f. Set the MTU.
12. (Optional) Click to expand MAC address denylist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Click to expand MAC address denylist.
b. For Add MAC address, click .
c. Type the MAC address.
13. (Optional) Click to expand MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Click to expand MAC address allowlist.
b. For Add MAC address, click .
c. Type the MAC address.
14. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX10 User Guide
for information about configuring the DHCP server.
for information about configuring DHCP relay.
Local Area Networks (LANs)
147