Digi IX10 User Manual page 346

Virtual Private Networks (VPN)
e. For Recovery type, select the type of recovery action. If multiple recovery actions are
configured, they are performed in the order that they are listed.
n
n
n
n
n
IX10 User Guide
Change default gateway: Increases the interface's metric to change the default
gateway.
If Change default gateway is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Increase metric to change active default gateway: Increase the interface's
l
metric by this amount. This should be set to a number large enough to change
the routing table to use another default gateway. The default is 100.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Restart interface.
If Restart interface is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Reset modem: This recovery action is available for WWAN interfaces only.
If Reset modem is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Switch to alternate SIM: Switches to an alternate SIM. This recovery action is
available for WWAN interfaces only.
If Switch to alternate SIM is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Reboot device.
If Reboot device is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
IPsec
346