Digi IX10 User Manual page 302

Routing
Task 3: Configure the IP address for the VRRP interface, ETH, on device two
1. Click Network > Interfaces > ETH > IPv4
2. For Address, type 192.168.3.2/24.
3. For Default gateway, type the IP address of the VRRP interface on the master device,
configured above in
Task 4: Configure SureLink for ETH on device two
1. Click Network > Interfaces > ETH > IPv4 > SureLink.
2. Click Enable.
3. For Interval, type 15s.
4. Click to expand Test targets > Test target.
5. For Test Type, select Ping test.
6. For Ping host, type https://remotemanager.digi.com.
Task 5: Configure the DHCP server for ETH on device two
1. Click to expand Network > Interfaces > ETH > IPv4 > DHCP Server
2. For Lease range start, type 200.
3. For Lease range end, type 250.
4. Click Advanced settings.
5. For Gateway, select Custom.
IX10 User Guide
Task 3, step 2 (192.168.3.1).
Virtual Router Redundancy Protocol (VRRP)
302