Digi IX10 User Manual page 109

Interfaces
n
n
IX10 User Guide
(config network interface my_wan
test_commands "string"
(config network interface my_wan surelink tests 1)>
tcp_connection: Tests that the interface can reach a destination port on the
configured host.
If tcp_connection is selected, complete the following:
Set the hostname or IP address of the host to create a TCP connection to:
l
(config network interface my_wan surelink tests 1)> tcp_host
hostname/IP_address
(config network interface my_wan surelink tests 1)>
Set the TCP port to create a TCP connection to.
l
(config network interface my_wan surelink tests 1)> tcp_port
port
(config network interface my_wan surelink tests 1)>
other: Tests the status of another interface.
If other is selected, complete the following:
Set the interface to test.
l
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config network interface my_wan surelink tests 1)> other_
interface /network/interface/eth1
(config network interface my_wan surelink tests 1)>
Set the type of IP connection:
l
(config network interface my_wan surelink tests 1)> other_ip_
version value
(config network interface my_wan surelink tests 1)>
where value is one of:
any: Either the IPv4 or IPv6 connection must be up.
o
o both: Both the IPv4 or IPv6 connection must be up.
ipv4 The IPv4 connection must be up.
o
o ipv6: The IPv6 connection must be up.
The status required for the test to past.
l
(config network interface my_wan surelink tests 1)> other_
status value
(config network interface my_wan surelink tests 1)>
where value is one of:
Wireless Wide Area Networks (WWANs)
surelink tests 1)> custom_
109