Use Digi Remote Manager To Deploy And Run Containers - Digi IX10 User Manual

Containers

Use Digi Remote Manager to deploy and run containers

Note Container support must be enabled in Digi Remote Manager. Contact your Digi sales
representative for information.
1. In Remote Manager, create a Configuration template. See
instructions.
a. For the Settings step:
n
n
b. For the Containers step:
i. Click  to add a container to the configuration.
If no containers have been uploaded, or if Click  to upload a container file.
IX10 User Guide
Click Import from device and import settings from an appropriate device.
Configure a script to run the container:
i. Click System.
ii. Click Scheduled tasks > Custom scripts.
iii. Click  to add a custom script.
iv. Click the Label checkbox and type an identifiable label for the script, for
example, StartContainerScript.
v. To ensure that the script is always running:
i. Click the Run mode checkbox and select Interval.
ii. Click the Interval checkbox and enter a very short interval (for example,
one minute).
iii. Click the Run single checkbox, and toggle on to enable.
This will configure the device to regularly check if the script is running, but
only run if it is currently not running.
vi. For Commands, type the command to run the script. The command will vary
depending on how you want to run the script, and what application you want
to run inside the script. For example, to run the ping command inside a
container, the command would be:
lxc container_name /bin/ping -c 30 1.1.1.1
Use Digi Remote Manager to deploy and run containers
the Remote Manager User Guide for
788