Digi IX10 User Manual page 150

Interfaces
----------
connection_monitor
dhcpv6_server
(config network interface my_lan)>
View default settings for the IPv6 DHCP server:
(config network interface my_lan)> ipv6 dhcpv6_server ?
DHCPv6 server: The DHCPv6 server settings for this network interface.
Parameters
---------------------------------------------------------------------
----------
enable
(config network interface my_lan)>
d. Modify any of the remaining default settings as appropriate.
8. (Optional) To configure 802.1x port based network access control:
Note The IX10 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the IX10 device:
(config network interface my_lan)> 802_1x authentication enable true
(config network interface my_lan)>
b. Set the frequency period for reauthorization:
(config network interface my_lan)> 802_1x authentication reauth_period
value
(config network interface my_lan)>
where value is an integer between 0 and 86400. The default is 3600.
9. (Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MAC address to the denylist:
(config network interface my_lan)> add mac_denylist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
IX10 User Guide
Active recovery
DHCPv6 server
Current Value
true Enable
Local Area Networks (LANs)
150