Delete A Wwan - Digi IX10 User Manual

Interfaces
----
defaultip
defaultlinklocal
eth
eth
loopback
modem
modem
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about ETH1, enter show
network interface eth1:
> show network interface eth1
wan1 Interface Status
---------------------
Device
Zone
IPv4 Status
IPv4 Type
IPv4 Address(es)
IPv4 Gateway
IPv4 MTU
IPv4 Metric
IPv4 Weight
IPv4 DNS Server(s)
IPv6 Status
IPv6 Type
IPv6 Address(es)
IPv6 Gateway
IPv6 MTU
IPv6 Metric
IPv6 Weight
IPv6 DNS Server(s)
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a WWAN.

Follow this procedure to delete any WANs and WWANs that have been added to the system. You
cannot delete the preconfigured WAN, ETH1, or the preconfigured WWAN, Modem.

Web
IX10 User Guide
IPv4 up static
IPv4 up static
IPv4 up static
IPv6 up static
IPv4 up static
IPv4 up modem
IPv6 down modem
: eth1
: external
: up
: dhcp
: 10.10.10.10/24
: 10.10.10.1
: 1500
: 1
: 10
: 10.10.10.2, 10.10.10.3
: up
: dhcpv6
: fe00:2404::240:f4ff:fe80:120/64
: ff80::234:f3ff:ff0e:4320
: 1500
: 1
: 10
: fd00:244::1, fe80::234:f3f4:fe0e:4320
Wireless Wide Area Networks (WWANs)
setup eth 10
setup eth 0
internal eth 5
internal eth 5
loopback loopback
external wwan1
external wwan1
10
10
10
10
0 10
3 10
3 10
140