Digi IX10 User Manual page 265

Routing
3. Click Network > Routes > Policy-based routing.
4. Click the  to add a new route policy.
5. For Label, type Domain-based policy.
6. For Interface, select ETH1.
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Any.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select Domain.
c. Click to expand Domains.
d. Click the  to add a new domain.
e. For Domain, type youtube.com.
You can add additional domains by repeating the last two steps.
IX10 User Guide
IP routing
265