Configure A Static Route - Digi IX10 User Manual

Routing

Configure a static route

A static route is a manually configured routing entry. Information about the route is manually entered
rather than obtained from dynamic routing traffic.
Required configuration items
The destination address or network.
n
The interface to use to reach the destination.
n
Additional configuration items
A label used to identify this route.
n
The IPv4 address of the gateway used to reach the destination.
n
The metric for the route. When multiple routes are available to reach the same destination, the
n
route with the lowest metric is used.
The Maximum Transmission Units (MTU) of network packets using this route.
n
To configure a static route:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX10 User Guide
Use Digi Remote Manager to view and manage your
IP routing
248