Digi IX10 User Manual page 134

Interfaces
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WWAN or edit an existing one:
To create a new WWAN named my_wwan:
n
(config)> add network interface my_wwan
(config network interface my_wwan)>
To edit an existing WWAN named my_wwan, change to the my_wwan node in the
n
configuration schema:
(config)> network interface my_wwan
(config network interface my_wwan)>
4. Set the appropriate firewall zone:
(config network interface my_wwan)> zone zone
(config network interface my_wwan)>
See Firewall configuration
5. Select a cellular modem:
a. Enter modem device ? to view available modems and the proper syntax.
(config network interface my_wwan)> modem device ?
Device: The modem used by this network interface.
Format:
modem
Current value:
(config network interface my_wwan)> device
b. Set the device:
(config network interface my_wwan)> modem device modem
(config network interface my_wwan)>
6. Set theSIM matching criteria to determine when this WWAN should be used:
(config network interface my_wwan)> modem match value
(config network interface my_wwan)>
Where value is one of:
any
n
carrier
n
Set the cellular carrier must be in active for this WWAN to be used:
IX10 User Guide
for further information.
Wireless Wide Area Networks (WWANs)
134