Digi IX10 User Manual page 795

Containers
7. Enable Start on boot to configure the container to start when the system boots.
a. For Restart timeout, set the amount of time to wait before restarting the container, if the
container ever stops. The default timeout of 0s means that if the container stops, it will
not be restarted.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Restart timeout to ten minutes, enter 10m or 600s.
8. (Optional) Type any Optional parameters for the container. Parameters are in the format
accepted by the lxc utility.
9. (Optional) Click to expand Mounted directories to configure system directories that will be
mounted inside the container. Any mounted directories need to be accessible to a non-
privileged user.
a. For Add Directory, click .
b. For Directory, type the pathname of the directory to be mounted. The leading slash
should be removed, so for example to mount the /opt directory, type opt.
10. (Optional) Click to expand Serial ports to assign serial ports that the container will have
access to.
a. For Add Port, click .
b. For Port, select the serial port.
11. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new container:
(config)> add system container name
(config system container name)>
where name is the
New access points are enabled by default.
4. New containers are enabled by default. To disable:
(config system container name)> enable false
(config system container name)>
IX10 User Guide
Configure a container
795