Digi IX10 User Manual page 453

Virtual Private Networks (VPN)
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add vpn l2tp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
5. To add an L2TP access concentrator:
a. Add an LAC:
(config)> add vpn l2tp lac name
(config add vpn l2tp lac name)>
where name is the name of the LAC. For example, to add an LAC named lac_tunnel:
(config)> add vpn l2tp lac lac_tunnel
(config vpn l2tp lac lac_tunnel)>
LACs are enabled by default. To disable:
IX10 User Guide
defaultlinklocal
eth
loopback
modem
config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Default Link-local IP
ETH
Loopback
Modem
L2TP
453