Digi IX10 User Manual page 269

Hide thumbs Also See for IX10:

Table of Contents

4. Configure the WAN interfaces to use the new zones:

a. Configure the cellular WAN interface:

i. Click Network > Interfaces > .

ii. For Zone, select CellularWAN.

b. Configure the Ethernet WAN interface:

i. Click Network > Interfaces > .

ii. For Zone, select EthernetWAN.

5. Configure the policy-based route for traffic from the client device that will be sent over the

cellular WAN:

a. Click Network > Routes > Policy-based routing.

b. Click the  to add a new route policy.

c. For Label, type VoIP phone.

d. For Interface, select .

e. Configure the source as the MAC address of the VoIP phone:

i. Click to expand Source address.

ii. For Type, select MAC address.

iii. For MAC address, type 26:88:0E:23:50:C2.

f. Configure the destination zone:

i. Click to expand Destination address.

ii. For Type, select Zone.

iii. For Zone, select CellularWAN.

IX10 User Guide