Digi IX10 User Manual page 200

Serial port
IX10 User Guide
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX10
n
device:
(config)> add serial port1 service ssh acl interface end
value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
eth
loopback
modem
config)>
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add serial port1 service ssh acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
Configure Remote Access mode
Default IP
Default Link-local IP
ETH
Loopback
Modem
200