Digi IX10 User Manual page 408

Hide thumbs Also See for IX10:
Table of Contents

Advertisement

Virtual Private Networks (VPN)
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config vpn openvpn client openvpn_client1 surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add vpn openvpn client openvpn_client1 surelink actions end
(config vpn openvpn client openvpn_client1 surelink actions 0)>
c. New actions are enabled by default. To disable:
(config vpn openvpn client openvpn_client1 surelink actions 0)> enable
false
(config vpn openvpn client openvpn_client1 surelink actions 0)>
IX10 User Guide
Set the interface to test.
l
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn openvpn client openvpn_client1 surelink tests
1)> other_interface /network/interface/eth1
(config vpn openvpn client openvpn_client1 surelink tests
1)>
Set the type of IP connection:
l
(config vpn openvpn client openvpn_client1 surelink tests 1)>
other_ip_version value
(config vpn openvpn client openvpn_client1 surelink tests 1)>
where value is one of:
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
o
The status required for the test to past.
l
(config vpn openvpn client openvpn_client1 surelink tests 1)>
other_status value
(config vpn openvpn client openvpn_client1 surelink tests 1)>
where value is one of:
up: The test will pass only if the referenced interface is up and passing its
o
own SureLink tests (if applicable).
down: The test will pass only if the referenced interface is down or failing its
o
own SureLink tests (if applicable).
OpenVPN
408

Advertisement

Table of Contents
loading

Table of Contents