Enable Event Log Upload To Digi Remote Manager - Digi IX10 User Manual

Central management
serial
cellular
1
...
To disable a tuning parameter, set its value to false. For example, to turn off all reporting for
the serial port:
(config)> monitoring devicehealth tuning all serial rx bytes enabled
false
(config)> monitoring devicehealth tuning all serial tx bytes enabled
false
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable event log upload to Digi Remote Manager

You can configure your device to upload the event log to Digi Remote Manager, and configure the
interval between event log uploads.
To enable the event log upload, or disable it if it has been disabled, and to change the upload
interval:

Web
IX10 User Guide
Configure your device for Digi Remote Manager support
bytes
enable true
tx
bytes
enable true
rx
bytes
enable true
tx
bytes
enable true
rx
bytes
enable true
packets
enable true
(config)>
64