Ip Routing - Digi IX10 User Manual

Hide thumbs Also See for IX10:

Table of Contents

IP routing

The IX10 device uses IP routes to decide where to send a packet it receives for a remote network. The

process for deciding on a route to send the packet is as follows:

1. The device examines the destination IP address in the IP packet, and looks through the IP

routing table to find a match for it.

2. If it finds a route for the destination, it forwards the IP packet to the configured IP gateway or

3. If it cannot find a route for the destination, it uses a default route.

4. If there are two or more routes to a destination, the device uses the route with the longest

5. If there are two or more routes to a destination with the same mask, the device uses the route

with the lowest metric.

This section contains the following topics:

Configure a static route

Delete a static route

Policy-based routing

Configure a routing policy

Example: Dual WAN policy-based routing

Example: Domain-based routing with dual WAN

Example: Route traffic to a specific WAN interface based on the client MAC address

Routing services

Configure routing services

IX10 User Guide