Table of Contents
Advertisement
Services
To limit access based on firewall zones:
n
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click again to allow access through additional firewall zones.
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source )>
4. (Optional) Set a label for this location source:
(config service location source )> label "label"
(config service location source )>
5. Set the type of location source to server:
(config service location source )> type server
(config service location source )>
6. Set the UDP port that will receive incoming location messages.
(config service location source )> server port port
(config service location source )>
7. Click Access control list to configure access control:
8. 1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
See
Firewall configuration
for information about firewall zones.
Location information
529
Advertisement
Table of Contents
