Digi IX10 User Manual page 165

Interfaces
(config)> add network interface my_lan ipv4 dhcp_server advanced static_
lease end
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
See Configure a LAN
4. Set the MAC address of the device associated with this static lease, using the colon-separated
format:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> mac 00:40:D0:13:35:36
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
5. Set the IP address for the static lease:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> ip 10.01.01.10
(network interface my_lan ipv4 dhcp_server advanced static_lease 0)>
Note The IP address here should be outside of the DHCP server's configured lease range. See
Configure a DHCP server
6. (Optional) Set a label for this static lease:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> name label
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
7. Save the configuration and apply the change:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show current static IP mapping
To view your current static IP mapping:

Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Networking, click DHCP Leases.

Command line
IX10 User Guide
for information about creating a LAN.
for further information about the lease range.
Local Area Networks (LANs)
165