Configure An Openvpn Authentication Group And User - Digi IX10 User Manual

Virtual Private Networks (VPN)
Repeat this step to include additional firewall zones.
9. (Optional) Set additional OpenVPN parameters.
a. Enable the use of additional OpenVPN parameters:
(config vpn openvpn server name)> advanced_options enable true
(config vpn openvpn server name)>
b. Configure whether the additional OpenVPN parameters should override default options:
(config vpn openvpn server name)> advanced_options override true
(config vpn openvpn server name)>
c. Set the additional OpenVPN parameters:
(config vpn openvpn server name)> extra parameters
(config vpn openvpn server name)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure an OpenVPN Authentication Group and User

If username and password authentication is used for the OpenVPN server, you must create an
OpenVPN authentication group and user.
See Configure an OpenVPN server
username and password authentication. See
creating authentication groups and users.
IX10 User Guide
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config vpn openvpn server name)>
for information about configuring an OpenVPN server to use
IX10 user authentication
OpenVPN
for more information about
385