Digi IX10 User Manual page 762

Firewall
3. Click Firewall > Packet filtering.
4. Click the appropriate packet filtering rule.
5. Click Enable to toggle the rule between enabled and disabled.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Determine the index number of the appropriate port forwarding rule:
(config)> show firewall filter
0
action accept
dst_zone any
enable true
ip_version any
label Allow all outgoing traffic
protocol any
src_zone internal
1
action drop
IX10 User Guide
Packet filtering
762