Configure A Nemo Tunnel - Digi IX10 User Manual

Virtual Private Networks (VPN)

Configure a NEMO tunnel

Configuring an NEMO tunnel with a remote device involves configuring the following items:
Required configuration items
Enable the NEMO tunnel.
n
The NEMO tunnel is enabled by default.
The IP address of the NEMO virtual network interface.
n
The firewall zone of the NEMO tunnel.
n
The IP address of the NEMO home agent server. This is provided by your cellular carrier.
n
The home agent's authentication key. This is provided by your cellular carrier.
n
Home agent registration lifetime. This is provided by your cellular carrier.
n
The local network interfaces that will be advertised on NEMO.
n
Additional configuration items
The home agent Software Parameter Index (SPI).
n
Path MTU discovery.
n
Path MTU discovery is enabled by default. If it is disabled, identify the MTU.
Care of address: the local network interface that is used to communicate with the peer.
n
If set to Interface, identify the local interface to be used. Generally, this will be the
l
Wirelesss WAN (Modem).
If set to IP address, enter the IP address.
l
The local network of the GRE endpoint negotiated by NEMO.
n
If the local network is set to Interface, identify the local interface to be used.
l

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
IX10 User Guide
NEMO
466