Digi IX10 User Manual page 717

Hide thumbs Also See for IX10:

Table of Contents

User authentication

4. (Optional) Enable debug messages from the RADIUS client:

(config)> auth radius debug true

5. (Optional) Configure the NAS ID. This is a unique identifier for this network access server (NAS).

You can use the fully-qualified domain name of the NAS or any arbitrary string. If not set, the

default value is used:

If you are accessing the IX10 device by using the WebUI, the default value is for NAS ID is

If you are accessing the IX10 device by using ssh, the default value is sshd.

(config)> auth radius nas_id id

6. Add a RADIUS server:

a. Add the server:

(config)> add auth radius server end

(config auth radius server 0)>

b. Enter the RADIUS server's IP address or hostname:

(config auth radius server 0)> hostname hostname|ip-address

(config auth radius server 0)>

c. (Optional) Change the default port setting to the appropriate port:

(config auth radius server 0)> port port

(config auth radius server 0)>

d. Configure the amount of time in seconds to wait for the RADIUS server to respond. Allowed

value is any integer from 3 to 60. The default value is 3.

(config auth radius server 0)> timeout value

(config auth radius server 0)>

e. (Optional) Repeat the above steps to add additional RADIUS servers.

7. Add RADIUS to the authentication methods. Authentication methods are attempted in the

order they are listed until the first successful authentication result is returned. This example

will add RADIUS to the end of the list. See

adding methods to the beginning or middle of the list.

(config)> add auth method end radius

8. Save the configuration and apply the change:

(config)> save

Configuration saved.

IX10 User Guide

Remote Authentication Dial-In User Service (RADIUS)

User authentication methods

for information about