Use The Iperf Service - Digi IX10 User Manual

Services
Maximum
Connected
Disconnected
Expired
Subscriptions
-------------
Total
Shared
Message Store
-------------
Bytes
Messages
Retained messages : 40
PUBLISH Messages
----------------
Bytes sent
Bytes received
Messages sent
Messages received : 0
Messages dropped
>
3. Use the show mqtt
five, and fifteen minutes.
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Use the iPerf service

Your IX10 device includes an iPerf3 server that you can use to test the performance of your network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues, to determine, for example, whether a
cellular connection is providing expected throughput.
The IX10 implementation of iPerf3 supports testing with both TCP and UDP.
Note Using iPerf clients that are at a version earlier than iPerf3 to connect to the IX10 device's iPerf3
server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the IX10 device's iPerf3 server.
Required configuration items
Enable the iPerf server on the IX10 device.
n
An iPerf3 client installed on a remote host. iPerf3 software can be downloaded at
n
https://iperf.fr/iperf-download.php.
IX10 User Guide
: 5
: 1
: 0
: 0
: 1
: 1
: 151
: 35
: 0
: 0
: 0
: 0
command to return additional information, including averages over one,
Use the iPerf service
597