Installing A Fan Tray In An Ex9253 Switch - Juniper EX9253 Hardware Manual

3. Hold and lift the latch located on the inside of the fan tray to release it from the chassis.
4. Grasp the fan tray and pull it out approximately 1 to 3 inches.
5. Place one hand under the fan tray to support it, and pull the fan tray completely out of the chassis.
Figure 40: Removing a Fan Tray
SEE ALSO
EX9253 Cooling System | 21

Installing a Fan Tray in an EX9253 Switch

Before you begin to install a fan tray:
• Ensure you understand how to prevent electrostatic discharge (ESD) damage (ee
Electrostatic Discharge Damage
Ensure that you have the following parts and tools available:
• An ESD wrist strap
• A Phillips (+) screwdriver, number 2 (not provided)
).
Prevention of
112