Configuring The Modem - Juniper EX8208 Hardware Manual

loader> save
Press Enter. The serial console speed is now set to 115200 baud.
6. Boot the software:
loader> boot
The boot process proceeds as normal and ends with a login prompt.

Configuring the Modem

Before you connect the modem, you must configure the modem with the required port settings.
NOTE: The following procedure uses Hayes-compatible-modem commands to configure the
modem. If your modem is not Hayes-compatible, see the documentation for your modem for
the equivalent modem commands.
To configure the modem:
1. Connect the modem to the desktop or notebook computer.
2. Power on the modem.
3. From the computer, start your asynchronous terminal emulation application (such as Microsoft Windows
HyperTerminal) and select the COM port to which the modem is connected (for example, COM1).
4. Configure the port settings shown in
Table 70: Port Settings
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
Table 70 on page 186.
Value
115200
8
None
1
None
186