Connecting The Ex8200 To External Devices; Connect A Device To A Network For Out-Of-Band Management - Juniper EX8208 Hardware Manual

SEE ALSO
Powering Off an EX8200 Switch | 289

Connecting the EX8200 to External Devices

IN THIS SECTION

Connect a Device to a Network for Out-of-Band Management | 182

Connect a Device to a Management Console Using an RJ-45 Connector | 183
Connecting an EX8200 Switch to a Modem | 184
Connect a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 56: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see
1. Connect one end of the Ethernet cable to the management port on the device.
2. Connect the other end of the Ethernet cable to the management device.
Figure 56 on page 182
Figure 57 on page 183):
182