Connecting The Ex4300 To External Devices; Connect A Device To A Network For Out-Of-Band Management - Juniper EX4300 Series Hardware Manual

SEE ALSO
DC Power Supply in EX4300 Switches | 112
DC Power Supply LEDs in EX4300 Switches | 119

Connecting the EX4300 to External Devices

IN THIS SECTION

Connect a Device to a Network for Out-of-Band Management | 205

Connect a Device to a Management Console Using an RJ-45 Connector | 206
Connect an EX Series Switch to a Management Console Using the Mini-USB Type-B Console Port | 207
Connect a Device to a Network for Out-of-Band Management
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
205 shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 70: RJ-45 Connector on an Ethernet Cable
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
To connect a device to a network for out-of-band management (see
1. Connect one end of the Ethernet cable to the management port on the device.
Figure 70 on page
Figure 71 on page 206):
205