Ds3 Cleanup Procedures - Alcatel-Lucent 1665 Installation Manual

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
At the Switch Type: pull-down, select Manual.
........................................................................................................................................................................................................................
5
Click Apply.
Result:
the active path, the switch is from m2 to m1).
The Switch Request State: indicates Manual Switch.
........................................................................................................................................................................................................................
6
At the Switch Type: pull-down, select Clear.
........................................................................................................................................................................................................................
7
Click Apply.
........................................................................................................................................................................................................................
8
Repeat
........................................................................................................................................................................................................................
9
Check off the appropriate box in
E O
N D
........................................................................................................................................................

DS3 cleanup procedures

Delete the existing DS3 cross-connections
Before moving on to the next port to test, it is necessary to remove the cross-connection.
........................................................................................................................................................................................................................
1
Select Configuration > Cross-Connections...
........................................................................................................................................................................................................................
2
Use the Cross-Connection Wizard to Delete leg(s) of an existing cross-connection
associated with CP main-1, Port 1.
Result:
of the PRBS signal.
............................................................................................................................................................................................................................................................
6 - 2 6
The Active Path: indicates a change from m1 to m2 (or if m2 was originally
Step 1 through Step 7
S
F T E P S
The DS3 test set should indicate a blue (AIS) signal is being received in place
to verify a switch back to the original ring.
Table I-3, Installation acceptance checklist
DS3 cleanup procedures
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010