Alcatel-Lucent 1665 Installation Manual page 183

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
LNW66 (10/100T) installation (optional)
Follow this procedure only if installing LNW66 (10/100T) circuit packs into the Alcatel-
Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (A1, B1, C1
or D1) where the LNW66 circuit pack will be installed.
Note:
group.
........................................................................................................................................................................................................................
2
Remove the LNW66 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1 or D1 as required). Do NOT engage
the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion circuit pack slot (A2, B2, C2 or D2 as
required).
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
with LNW66 circuit packs.
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
The LNW66 or circuit pack can only be installed in slot 1 of any function
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
S
F T E P S
for each additional function group slot 1's to be equipped
Table I-3, Installation acceptance
Initial circuit pack installation
checklist.
4 - 2 3