Alcatel-Lucent 1665 Installation Manual page 240

Installation tests
............................................................................................................................................................................................................................................................
Ethernet port assignment verification testing
........................................................................................................................................................................................................................
1
Connect the Front CIT cable between the PC and the CIT/RS 232 jack of System
Controller and login to the shelf using the serial connection.
........................................................................................................................................................................................................................
2
Identify the function groups that contain an LNW66 or LNW74 (10/100T) circuit packs
with cabling for testing.
........................................................................................................................................................................................................................
3
Identify the RJ45 patch panel associated with the function groups identified above.
........................................................................................................................................................................................................................
4
Connect the RJ45 cable from the first RJ45 on the patch panel to the ethernet port on your
PC.
........................................................................................................................................................................................................................
5
Watch for the link LED to light on the PC's Ethernet card or wait for 30 seconds and then
disconnect the RJ45 cable from the patch panel.
........................................................................................................................................................................................................................
6
The Fault LED will start flashing on the LNW66 or LNW74.
........................................................................................................................................................................................................................
7
Verify that there is an inc. FE-LAN LOS alarm associated with the ethernet port where the
signal was removed. Use the Alarm List button on the CIT system view.
........................................................................................................................................................................................................................
8
Select Configuration > Update System... > Update All.
Result:
........................................................................................................................................................................................................................
9
Connect the RJ45 cable to the next jack on the RJ45 patch panel and repeat starting at
5 until all connected jacks have been tested.
........................................................................................................................................................................................................................
10
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
6 - 3 0
The flashing fault LED on the LNW66 or LNW74 will clear.
S
F T E P S
LNW66 and LNW74 (10/100T) TX ethernet cabling testing
Table I-3, Installation acceptance checklist
Step
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010