Alcatel-Lucent 1665 Installation Manual page 358

Pluggable transmission module installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper circuit pack type and the port
socket being equipped with the pluggable module. Make sure the transmission rate (OC-3,
OC-12, OC-48, OC-192, 100Base Ethernet GbE, FICON) matches the rate of the PTM
See Table E-1, "Alcatel-Lucent approved pluggable transmission modules" (p.
Note:
maintain cleanliness during storage and/or transportation. It is recommended that the
dust plug be kept in place to maintain cleanliness. With proper care and handling,
cleaning the pluggable modules should not be necessary.
........................................................................................................................................................................................................................
2
Check the ports for cleanliness and clean the pluggable module if necessary. See
Appendix A, "Fiber
........................................................................................................................................................................................................................
3
Insert the pluggable module in the required socket of the circuit pack faceplate, then
wiggle the module to verify that it is locked in the socket. See
modules (PTM)" (p.
Note:
guidelines" (p. 9-18)
........................................................................................................................................................................................................................
4
Repeat
........................................................................................................................................................................................................................
5
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
E - 2
Pluggable modules are shipped with a dust plug installed into the ports to
cleaning".
NOTICE
Never mechanically clean the receive (RX) port. Air blows only should be used
on the receive (RX) port. The receive (RX) port contains a lens for focusing a
wide input. The lens is more easily scratched than cleaned.
E-1). Verify that all unused sockets are equipped with dust plugs.
If installing PTMs in a LNW705, see
for installation guidelines.
Step 1 through Step 3
S
F T E P S
Table 9-2, "XM10G/8 PTM port
if more modules need to be installed.
Table I-3, Installation acceptance
Pluggable transmission modules (PTM)
E-11).
"Pluggable transmission
checklist.
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010