Alcatel-Lucent 1665 Installation Manual page 215

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
5
Next to OSI Over DCC, click disabled.
........................................................................................................................................................................................................................
6
Click Apply.
........................................................................................................................................................................................................................
7
From the Port AID: pull-down, select dcc-m2-1.
........................................................................................................................................................................................................................
8
Next to OSI Over DCC, click disabled.
........................................................................................................................................................................................................................
9
Click Apply.
........................................................................................................................................................................................................................
10
Click Close.
........................................................................................................................................................................................................................
11
If there are any FAULT LEDs on or flashing, press the UPD/INIT push button on the
SYSCTL circuit pack.
Note:
loopback at the DSX-3 on all ports. If loopbacks are used, make sure to take down any
cross-connections.
........................................................................................................................................................................................................................
12
If there are still FAULT LEDs on, replace the respective circuit pack.
........................................................................................................................................................................................................................
13
Disconnect the office alarm cable until all procedures and testing have been completed.
........................................................................................................................................................................................................................
14
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
LNW16 (DS3/EC1) circuit pack require either a 75-ohm termination or a
S
F T E P S
Table I-3, Installation acceptance
Clearing alarms
checklist.
6 - 5