Alcatel-Lucent 1665 Installation Manual page 173

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Remove the second OC-48 OLIU from the packing material.
........................................................................................................................................................................................................................
5
Identify the M2 slot on the Alcatel-Lucent 1665 DMX high-capacity shelf. See
"Alcatel-Lucent 1665 DMX high-capacity shelf" (p.
........................................................................................................................................................................................................................
6
Place the second OLIU circuit pack into the M2 slot on the Alcatel-Lucent 1665 DMX
high-capacity shelf. Do NOT engage the circuit pack in the backplane connector.
Important!
to provide proper air flow for cooling. Always use Main-1 (M1) for shelves equipped with
only one main pack.
........................................................................................................................................................................................................................
7
Check off the appropriate box in
E O
N D
........................................................................................................................................................
OC192 main OLIU installation
Follow this procedure to install the OC-192 OLIU circuit packs in the Alcatel-Lucent
1665 DMX high-capacity shelf. Verify
Table 4-5, OC192 circuit packs with 48 STS-1s of vt switch fabric
circuit packs with 192 STS-1s of vt switch fabric
........................................................................................................................................................................................................................
1
Remove the first OC-192 OLIU circuit pack from the packing material.
........................................................................................................................................................................................................................
2
Identify the M1 slot on the Alcatel-Lucent 1665 DMX high-capacity shelf. See
"Alcatel-Lucent 1665 DMX high-capacity shelf" (p.
........................................................................................................................................................................................................................
3
Place the OC-192 OLIU circuit pack into the M1 slot on the Alcatel-Lucent 1665 DMX
shelf. Do NOT engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Remove the second OC-192 OLIU from the packing material.
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
If any of the Main slots are to remain unequipped, install a blank circuit pack
S
F T E P S
4-9).
Table I-3, Installation acceptance
Switch fabric compatibility (p. 4-8)
(VLF),
4-9).
Initial circuit pack installation
Figure 4-2,
checklist.
using
and Table 4-6, OC192
Figure 4-2,
4 - 1 3