Connecting The Ring (Mains) To The Wdmx - Alcatel-Lucent 1665 Installation Manual

WDMX setup and testing: integration procedures
........................................................................................................................................................................
Note:
customer.
................................................................................................................................................
14
Disconnect test set(s) and fiber jumper from ports.
................................................................................................................................................
15
Check off the appropriate box in
E O
N D
........................................................................................................................................................

Connecting the ring (Mains) to the WDMX

Description
This section provides guidance on how to integrate an OC-48/OC-192 into the WDMX.
Depending on the Main circuit packs and the port rate, the ring can be integrated through
the LNW705 and/or the LNW785. All of the OC-48 Main circuit pack can be integrated
into the LNW705, however only the LNW59 and LNW502 can be integrated directly into
the LNW785 providing the circuit pack is equipped with one of the compatible PTMs
listed in
Important!
span between LNW785s or the span between the two LNW705s is established while
the second is that this is a new turn-up and not on an existing network.
LNW705/OC-48
The LNW705 span is established and tested using
muxponder" (p. 9-6)
WDMX circuit pack. Main 1 is always referred to as the West direction, while Main 2 is
the East
................................................................................................................................................
1
Determine the direction of the Span, Main 1 or Main 2.
................................................................................................................................................
2
Install an OC-48 PTM in the assigned port slot. See
Lucent approved pluggable transmission modules" (p.
Note:
Both ends of the circuit must have the PTM installed in the same port.
........................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
Test duration may be determined by engineering specification or by the end
S
F T E P S
Table 9-1, "Channel/port assignments" (p.
The procedures in this section make two assumptions, the first is that the
procedure. In some instances, only one direction may be added to the
The OC-48 PTM is restricted to ports 1, 3, 5, and 7.
Table I-3, Installation acceptance
9-17).
"Turn up and test the LNW705
Appendix
E-11).
Connecting the ring (Mains) to the WDMX
checklist.
E, Table E-1, "Alcatel-
9 - 1 1