Led Test - Alcatel-Lucent 1665 Installation Manual

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
12
Verify transmission at the patch panel. There should be no alarms at the test set.
........................................................................................................................................................................................................................
13
Select Fault > Analysis > Loopback...
........................................................................................................................................................................................................................
14
Choose the correct port on the OC-48 CP and click Select.
........................................................................................................................................................................................................................
15
Click on Release.
........................................................................................................................................................................................................................
16
Click Apply.
........................................................................................................................................................................................................................
17
Verify loss of transmission at the patch panel. This should be evident by a SONET alarm
and a loss of pattern alarm.
........................................................................................................................................................................................................................
18
Repeat this section for all OC-48 ports.
........................................................................................................................................................................................................................
19
Check off the appropriate box in
E O
N D
........................................................................................................................................................

LED test

Description
This test verifies proper operation of all LEDs on the Alcatel-Lucent 1665 DMX circuit
packs. Operation of all the LEDs is necessary to assist in trouble isolation.
Note:
or shelf and replace the faulty unit.
Note:
for all valid circuit pack positions.
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
S
F T E P S
If there are any LED failures, determine if the problem is with the circuit pack
If the shelf is not fully equipped, move circuit packs around and repeat the test
Table I-3, Installation acceptance
LED test
checklist.
6 - 5 1