Alcatel-Lucent 1665 Installation Manual page 311

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
3
Install an OC-3/OC-12/OC-48 PTM in Port 1 of the LNW705 [see
"Pluggable transmission modules (PTM)" (p.
Note:
For purposes of this document, the examples in the procedures below are equipped
with an OC48 PTM. Any other signal listed in
modules (PTM)" (p. E-1)
Table 9-2, "XM10G/8 PTM port guidelines" (p. 9-18)
................................................................................................................................................
4
Login to the Alcatel-Lucent 1665 DMX using the WaveStar
................................................................................................................................................
5
Provision the PTM/OTU-2
Select Configuration > Equipment from the System View
................................................................................................................................................
6
Click the "+" next to XM10G/8 circuit pack to expand the list.
................................................................................................................................................
7
Highlight the PTM sc9 and click Select.
................................................................................................................................................
8
Enter the Frequency in the Expected Frequency and click Apply.
Note:
column in
................................................................................................................................................
9
Highlight the Port 1 and click Select.
................................................................................................................................................
10
Set the Signal type to match the PTM type, using the pull down window (for example if
the PTM is a OC48SR1-I1
................................................................................................................................................
11
Perform a single node self test by connecting an OC-48 test set to Port 1, while observing
the proper optical power levels and cleaning procedures.
Insert a 15 dB LBO into the input of Port 9 and connect a fiber from the output of Port 9 to
the input of Port 9.
........................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
The PTMs at both ends of the circuit must be the same rate.
could be substituted, however use the guidelines set in
The frequency is determined by the PTM inserted in Port 9. See the LNW705
Table 9-1, "Channel/port assignments" (p. 9-17)
, set the Signal Type to OC48) and click
Turn up and test the LNW705 muxponder
Appendix
E-1)].
Appendix E, "Pluggable transmission
for the port restrictions.
®
CIT.
for acceptable values.
Apply
E,
.
9 - 7