Alcatel-Lucent 1665 Installation Manual page 213

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
3
From the CIT GUI, select Configuration > Equipment...
........................................................................................................................................................................................................................
4
Select the desired DS1 port by clicking the "+" sign next to the CP and VT Group.
........................................................................................................................................................................................................................
5
Highlight the port and click Select.
From the pull-down next to Line Build Out: choose the LBO value determined in
........................................................................................................................................................................................................................
6
If a change is made click Apply.
........................................................................................................................................................................................................................
7
Repeat
populated with DS1 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Setting DS3/EC1 and TMUX LBOs
The DS3/EC1 and TMUX cabling will be tested with all ports provisioned for DS3. Set
DS3 LBO values as follows.
........................................................................................................................................................................................................................
1
See the following table of cable lengths and LBO values. Determine the LBO value
corresponding to the DS3 (TMUX) cables installed:
Table 6-1 Cable lengths (feet)
LBO Value
IN
OUT
........................................................................................................................................................................................................................
2
From the CIT GUI, select Configuration > Equipment...
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
Step 2 through Step 6
S
F T E P S
734D
0 - 225
225-450
for all DS1 ports in all function unit slots which are
Table I-3, Installation acceptance
735A
0-125
125-250
LBO software settings
Step 2.
checklist.
6 - 3