Alcatel-Lucent 1665 Installation Manual page 260

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
1
Log on to the Alcatel-Lucent 1665 DMX shelf using the CIT software as described in the
Chapter 5, "Software download and circuit pack
software" (p.
........................................................................................................................................................................................................................
2
Select Configuration > Cross-Connections...
........................................................................................................................................................................................................................
3
Use the Cross-Connection Wizard to enter a new cross-connection at the STS48 rate,
UPSR Ring Add/Drop, between m1-1-1 and fn-1-1 (fn will be a,b,c,d or g depending on
the slot where the OC-48 CP is located).
This command creates a cross-connect to map the first STS-48 of an OC-48 circuit pack to
the first STS-48 of the Main OLIUs.
........................................................................................................................................................................................................................
4
Verify transmission at the patch panel. There should be no alarms at the test set.
........................................................................................................................................................................................................................
5
Select Configuration > Cross-Connections...
........................................................................................................................................................................................................................
6
Use the Cross-Connection Wizard to Delete leg(s) of an existing cross-connection
associated with CP main-1, Port 1 (the OC-48 cross-connection).
........................................................................................................................................................................................................................
7
Verify loss of transmission at the patch panel. This should be evident by a SONET alarm
and a loss of pattern alarm.
........................................................................................................................................................................................................................
8
Select Fault > Analysis > Loopback...
........................................................................................................................................................................................................................
9
Choose the correct port on the OC-48 CP and click Select.
........................................................................................................................................................................................................................
10
Click on Operate and Loopback Type: Facility.
........................................................................................................................................................................................................................
11
Click Apply.
This command creates a facility loopback on the OC-48 port of an OC-48 circuit pack.
............................................................................................................................................................................................................................................................
6 - 5 0
5-6).
OC-192 (low-speed) testing
installation", "Use of WaveStar
Alcatel-Lucent 1665 DMX R9.0
®
CIT
365-372-304R9.0 Issue 2
July 2010