............................................................................................................................................................................................................................................................

Remove the test set connections from the DSX-3.

Select Configuration > Update System... > Update All.

Result:

from the DSX-3.

Repeat the

the

DS3 non-terminating transmission (optical main OLIU) (p. 6-22)

Delete the existing DS3 cross-connections (p. 6-26)

remaining DS3 tributaries of the Function unit, substituting the following address

information within the Cross-Connection Wizard. This is necessary in order to ensure that

the cabling of each port address is correct.

The table below lists the tributaries and cross-connections for all DS3s associated with a

function group.

When testing cabling for a Function unit slot other than a, replace the

addresses with the letter (

Table 6-3 DS3 cross-connections

Tributary @ DSX-3

Alcatel-Lucent 1665 DMX R9.0

365-372-304R9.0 Issue 2

July 2010

This command will remove alarms generated by removing the test signals

DS3 terminating equipment loopback testing (optical main OLIUs) (p. 6-18)

, or

Cross-Connection

m1-1-1,a1-1

m1-1-2,a1-2

m1-1-3,a1-3

m1-1-4,a1-4

m1-1-5,a1-5

m1-1-6,a1-6

m1-1-7,a1-7

m1-1-8,a1-8

m1-1-9,a1-9

m1-1-10,a1-10

m1-1-11,a1-11

m1-1-12,a1-12

procedure to test each of the

) corresponding to the Function unit slot under test.

DS3 cleanup procedures

procedure and the

in each of the

6 - 2 7

Table of Contents

Alcatel-Lucent 1665 Installation Manual page 237

Related Manuals for Alcatel-Lucent 1665

Related Products for Alcatel-Lucent 1665

Table of Contents